Rear panels cut

Got the shop cleaned up a little more this morning in some chilly low 40s and then started cutting out the rear panels. I got the rear side panels, bilge panels and bottom cut out for both boats. The jigsaw cut through the two sheets of 5 mm Tri-ply underlayment very cleanly. It took me about  hours to get set up and all the pieces cut. Tomorrow I hope to finish all the plywood cuts.

Rear panels cut

Rear panels cut

  1. cut out remaining plywood pieces from the 5 mm underlayment
  2. cut out temporary forms from MDF
  3. start gluing the SYP strips from Matt to use for blocking around the bulkheads
  4. epoxy the panels into full lengths
  5. build bulkheads

Hours 2/4

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s